Newer builds, bigger loads — EV, hot tubs, shops and generators. Panels, EV chargers, generators, remodel wiring and the kind of troubleshooting that actually finds the problem.
Covington and the Maple Valley corridor are newer than most of our service area, and that changes what people call about. There is far less knob-and-tube and far more "we bought two EVs and the panel is full." Homes from the 1990s through the 2010s here were built with adequate services but very few spare circuits, and the lots are big enough that detached shops, hot tubs, generators and outbuilding feeds come up constantly.
| Electric utility | Puget Sound Energy |
|---|---|
| Electrical permits & inspection | Washington State L&I |
| County | King County |
| Contractor license | WA OSHIETB778P8 · Administrator OSHIETB750DR · UBI 605-804-596 |
| Bonded & insured | Yes — documentation available on request |
| Booking | 253-268-6287 · text a photo · Bookings@ccelectricllc.com |
Usually, yes. Most modern Level 2 chargers support power sharing, which lets two units split one circuit's capacity so the load calculation stays inside your existing service. That is almost always cheaper than a service upgrade plus PSE coordination. We will run the calculation and show you both numbers.
Yes. A spa or hot tub needs a dedicated GFCI-protected circuit, a disconnect within sight but at a code-required distance from the water, and correct bonding. It is a permitted job inspected by Washington State L&I. This is one of the most common items we find installed wrong by a previous non-licensed installer.
Covington and Maple Valley sit in tree-heavy PSE territory where fall and winter windstorms take lines down, and outages here tend to run longer than they do in dense areas. A manual interlock kit with an inlet box is the inexpensive version — you back-feed the panel from a portable generator safely and legally. An automatic standby generator with a transfer switch is the no-thinking version. Both are permitted work.
Washington State L&I. We pull the permit under our contractor license and meet the inspector on site.
More general Washington electrical questions — permits, code, costs, inspections — are answered on the electrical FAQ page.
Text a photo of your panel or your problem and you will usually get a real answer back the same day. Or fill this out and we will call you.